This is an old revision of the document!
Rebuilt motor came back for leg machine but could not get it to work. Motor seems to work fine, but channel B of encoder seems to be non existent. Finally gave up and packed it up and sent it back to Paragon. The encoder is the R8023D-500-1/4-5-LD, P/N 74517-008. Edward R. Burk Product Manager RENCO Encoders Inc. Phone: 805-562-1186 Cell: 805-689-0421 Fax: 805-562-1150 Email: eburk@heidenhain.com The person above was kind enough to ID the encoder via a picture I sent him. He also emailed a 2 page manual to me: C:pdfelectrocraftR80_1992.pdf I made a quick drawing of the P4 connector on the electrocraft controller so I don't have to trace lines again. C:dwgelectrocraft_renco_encoder.dwg wiring is from top to bottom: I- brown I+ orange B- blue B+ green A- yellow A+ white
pwr- black pwr+ red
call Chad at 704 398 6970 = Paragon Atlantic Job 453509 PO 47847 RGA 53290
previous note is at http://metalbush.com/journal/past.php?id=61